Quiet Soak; Temperature Display And Adjustment; Factory Default Settings; Heat Light - Marquis e-serie Owner's Manual

marquis sp a cont rol ope rat ion

QUIET SOAK

Pressing the QUIET SOAK pad will turn off all pump op-
eration. This is a useful feature when you want to soak
in the hot water with no jets running. The QUIET SOAK
feature will last 60 minutes and then resume normal
operation. Pressing any of the jet pads will override the
QUIET SOAK feature and turn on the pumps. Or you
can simply press the QUIET SOAK pad to exit the mode.
Turning the LED lights on and off will not affect the QUI-
ET SOAK mode. The yellow LED indictor by the QUIET
SOAK pad will illuminate anytime this feature is engaged.
Note: If the system is heating it will take a few mo-
ments for the quiet soak feature to engage.

TEMPERATURE DISPLAY AND ADJUSTMENT

Factory Default Settings:

• Temperature: 100°F (38°C)
To adjust the temperature of the water, press either
the TEMP + or TEMP – pad. The display always shows
actual water temperature. The first press of the pad will
display the set temperature and begin to flash. Continue
to press the TEMP + or TEMP – to reach the desired set
temperature. Once the display stops blinking the new
temperature setting will be set. The factory default set-
ting is 100°F (38°C). The minimum temperature that can
be set is 80°F (27°C) and the maximum temperature
that can be set is 104°F (40°C).

HEAT LIGHT

The HEAT light illuminates when the heater is on. The
pump circulates on low-speed whenever the thermostat
calls for heat.
HEAT MODE
Your spa comes preset in the standard heat mode. The
heat mode can be adjusted to one of three different set-
tings.
MODE
To change the mode of operation, press the MODE pad
to begin. Pressing the MODE pad will show the cur-
rent setting which will begin flashing in the panel display.
To change, press the TEMP – pad to scroll through the
selections of Std, Ecn, and Slp. Once the desired mode is
showing in the display, press MODE pad.
37