Spa Control Operation; Jets 2/Temperature/Soak/Timer/Light; User Programming - Marquis 660 Owner's Manual

spa control operation

Jets 2 (two Pump models only)
Press Jets 2 button to turn on pump two high speed. Pressing a second
time will turn the pump off. The high speed of pump 2 will run for 15 minutes
and then turn off. To restart the pump, press the Jets 2 button.
adjusting temperature (factory default 100° F)
To adjust the temperature of the water, press the Temp +/ – button. The
display always shows actual water temperature. The first press of the but-
ton will display the set temperature and begin to flash. Continue to press or
hold the Temp +/ – to reach the desired set temperature. Once the display
stops blinking the new temperature setting will be set. The factory default
setting is 100° F (38° C). The minimum temperature that can be set is 80° F
(27° C) and the maximum temperature that can be set is 104° F (40° C). If
a lower set temperature is desired, see User Programming section – Dual
Temperature Range.
soak
Pressing the Soak button will turn off all pump operation. This is a useful fea-
ture when soaking in the hot water with no jets running is desired. The Soak
feature will last 60 minutes and then resume normal operation. Pressing
any jet button will override the soak feature and turn on the pumps or you
can simply press the Soak button to exit the mode. Turning the LED lights
on and off will not affect the quite soak mode. The yellow LED indictor light
under the LCD display will illuminate anytime this feature is engaged.
note: If the system is heating it will take a few moments for the Quiet Soak
feature to engage.
timer
Press the Timer button to start the timer. The display will start at E00 and
begin timing how long you have been in the spa or using a certain feature.
"E" is for elapsed and the two trailing characters track time in one minute
intervals. The display will alternate with the current water temperature every
10 seconds. The timer will continue to run up to 60 minutes. To turn off,
press the Timer button one time. The yellow LED indictor below the LCD
display will illuminate anytime this feature is running.
light
Press the Light button to turn the interior spa lights on and off. Pressing
the button repeatedly (within 2-3 seconds of each press) will allow for color
scrolling of the LED lights. If left on the lights will run for 60 minutes and then
turn off automatically.

user ProGramminG

The following features allow for additional control and setting of the on-
board electronics. In most cases the factory default settings are adequate
for normal use and operation. To access any of the following features press
Temp +/- and then Light: then scroll through the features by continuing to
press the Light button.
26