Smart Technologies 2000i-DVX Installation Manual page 58

Port Label (Type)
Power (custom)
Video IN (RCA - F)
Audio L/Mono (RCA - F)
Audio R (RCA - F)
Unlabeled (RCA -F)
Computer 1 IN (DB 15 - F)
Audio (RCA - F)
Computer 2 IN (DB 15 - F)
S-video IN (S-video - F)
Audio L/Mono (RCA -F)
Audio R (RCA -F)
Audio OUT (RCA -F)
Monitor OUT (DB 15 - F)
PC Control (8 pin mini DIN -
F)
6. Grasp the view port cover in the middle of each short edge and pull it away from the unit.
7. Using a pencil, mark the projector plate with the current position of the three screws that attach
the projector to the plate.
8. Loosen but do not remove these three screws using the TORX key in the accessory kit.
Carefully pull the projector towards you and then tighten the three screws.
9. Note the lettered and numbered positions of the two thumbscrews on the left side.
Cable Label (Factory
Setting)
AC IN
RGB 1 IN
PC Control
Lift from here
Maintenance and Troubleshooting
Your Current
Configuration
Lift from here
47