Smart Technologies 2000i-DVX Installation Manual page 26

NOTE: There is a three-second delay before the alternate display source appears. Also, when you
switch to another source (such as the internal computer), and then press the VCR/DVD Player
button, the last active video source will always appear.
You'll need the following cables to connect a VCR or DVD player to the 2000i:
• an RCA composite video cable or an S-video cable
• standard red and white RCA stereo audio cables
To connect a VCR to the 2000i (composite video connection)
1. Turn off the projector.
2. Connect the yellow RCA video connector on an RCA composite video cable (not provided) to
the Video Output jack on the VCR/DVD player. This jack may be labeled "To Monitor".
3. Plug the other end of the cable into the Video IN connector on the projector.
NOTE: If you're using an S-video cable, connect it to the S-video OUT connector on the VCR/
DVD player, and then plug the other end directly into the S-video IN connector on the
projector. Of course, if you connect the VCR to the projector's S-video IN connector, you won't
be able to use an S-video cable to connect a DVD player.
Setting Up Your 2000i
Video IN
Composite Video Cable
from VCR
15