Table of Contents
Advertisement
The Switch Information shows the type of switch module and its MAC
Address (assigned by the factory and unchangeable). In addition, the Boot
PROM and Firmware Version numbers are shown. This information is helpful
to keep track of PROM and firmware code updates and to obtain the switch
module MAC address for entry into another network device address table, if
necessary.
You can also enter the name of the System, its location, and the name and
telephone number of the system administrator. It is recommended that the
person responsible for the maintenance of the network system that this switch
module is installed on be listed here.
IP Setup
Some settings must be entered to allow the switch module to be managed from
an SNMP-based Network Management System, such as SNMP version 1 or, to
be able to access the switch module using the Telnet protocol.
The IP Setup window lets you specify how the switch module will be assigned
an IP address to allow it to be identified on the network.
The switch default IP address is 192.168.70.1xx, where xx depends on the
number of the bay into which you have installed the switch module, as shown
in Table 3 on page 44.
43
Chapter 5. Configuration through the Telnet interface
Advertisement
Table of Contents
