The following window will appear to verify that your new settings have been
saved to NVRAM:
Once the switch configuration settings have been saved to NVRAM, they
become the default settings for the switch. These settings will be used every
time that the switch module restarts.
Restoring default configuration values
The only way to change the configuration stored in NVRAM is to save a new
configuration using Save Changes, or to process a Load Factory Default
Configuration function from the Reboot menu. This will clear all settings and
restore them to their initial values listed in the BladeCenter 4-Port Gb Ethernet
Switch Module Installation and User's Guide. These are the configuration settings
that were entered at the factory and are the same settings that were present
when the switch was purchased.
38
IBM BladeCenter 4-Port Gb Ethernet Switch Module: Installation Guide