Cornelius Vanguard 245 Service Manual page 36

Vanguard 245 Service Manual
13. Syrup Tank Systems
Connect sanitizing solution tank, pressurized at 60 to 80-psi, into one of the syrup
systems.
Bag-in-Box Syrup System
Place all bag-in-box syrup containers syrup outlet tubes in container containing
sanitizing solution.
14. Sanitize the syrup system and dispensing valve as follows:
A. Place waste container under applicable dispensing valve.
B. Activate the dispensing valve for one minute to purge all water from and install
sanitizing solution in the syrup system and dispensing valve.
C. Continue to activate the dispensing valve in cycles ("ON" for 15-seconds, "OFF",
then "ON" for 15-seconds). Repeat "ON" and "OFF" cycles for 15-cycles.
15. Repeat steps 13 and 14 to flush water out of and install sanitizing solution in the
remaining syrup systems and dispensing valves.
16. Remove sanitizing solution source from the syrup system.
17. Allow sanitizing solution to remain in the syrup systems for not less than 10 or no
more than 15-minutes (max.) contact time.
WATER FLUSH SYRUP SYSTEMS
! WARNING: Flush sanitizing solution from the syrup systems as instructed.
Residual sanitizing solution left in the syrup systems could create a health
hazard.
18. Fill syrup tank (syrup tank system) or a five-gallon container (bag-in-box system) with
potable water.
19. Syrup Tank Systems
Connect syrup tank containing potable water, pressurized at 60 to 80 psi, into one of
the syrup systems.
Bag-in-Box Syrup System
Place all bag-in-box syrup containers syrup outlet tubes in container containing
potable water.
20. Flush sanitizing solution from the syrup system and the dispensing valve as follows:
A. Place waste container under applicable dispensing valve.
B. Activate the dispensing valve for one minute to purge all sanitizing solution out of
the syrup system and the dispensing valve.
© 2006, IMI Cornelius Inc.
- 30 -
301135000E