Cornelius Vanguard 245 Service Manual page 35

C. Continue to activate the dispensing valve in cycles ("ON" for 15-seconds, "OFF",
then "ON" for 15-seconds). Repeat "ON" and "OFF" cycles for 15-cycles.
6. Connect detergent solution to the remaining syrup systems and flush syrup out of the
syrup systems as instructed in step 5 preceding.
7. Remove detergent solution source from the syrup system.
FLUSH SYRUP SYSTEMS
8. Syrup Tank Systems
Connect syrup tank containing potable water, pressurized at 60 to 80-psi, into one of
the syrup systems.
Bag-in-Box Syrup System
Fill five-gallon container with potable water, then place all bag-in-box syrup containers
syrup outlet tubes in container containing potable water.
9. Flush detergent solution out of the syrup system and dispensing valve as follows:
A. Place waste container under applicable dispensing valve.
B. Activate the dispensing valve for one minute to purge all detergent solution and
flush out the syrup system.
C. Continue to activate the dispensing valve in cycles ("ON" for 15-seconds, "OFF",
then "ON" for 15-seconds). Repeat "ON" and "OFF" cycles for 15-cycles.
10. Connect potable water source to the remaining syrup systems and flush detergent
solution out of the syrup systems as instructed in step 9 preceding.
11. Remove potable water source from the syrup system.
SANITIZE SYRUP SYSTEMS
12. Using a clean syrup tank (syrup tanks system) or a five-gallon container (bag-in-box
system), prepare sanitizing solution using 70° F (21 °C) to 100° F (38° C) potable
water and 0.5 oz. (15 ml) of non-scented household liquid bleach that contains a
5.25 % sodium hypochlorite concentration to one gallon of potable water. This
mixture must not exceed 200 PPM of chlorine. Stir sanitizing solution to thoroughly
mix.
301135000E
Vanguard 245 Service Manual
- 29 -
© 2006, IMI Cornelius Inc.