2000 Expedition/Navigator Workshop Manual
4.
CAUTION: If removing the anti-lock speed sensor ring, discard it, and install a new anti-lock speed sensor ring during assembly.
Remove the anti-lock speed sensor ring, if necessary.
5. Using the special tools, remove the differential bearings, if necessary.
6. Remove the bolt and the differential pinion shaft.
7. NOTE: Do not clamp the special tool that has the 1/2-inch drive hole in it in the vise.
Position the special tool (without the 1/2 drive hole) in a suitable vise.
8. Position the differential case on the special tool.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/21/S...
Page 2 of 8
6/30/2011