General Set Up Screen - Briggs & Stratton Standby Generator Systems Installation & Start-Up Manual

General Set Up Screen

For general set up, press and hold the left arrow and right arrow
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was also set at
the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time. To update or change these
settings, follow the steps below.
SET DATE
(SET DATE)
or
SET TIME
(SET TIME)
or
or
SET EXERCISE CYCLE
(SET EXERCISE CYCLE)
EVENT LOG
(EVENT LOG)
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 30 SECONDS,
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
28
YEAR
FLASHING FLASHING
or
HOURS
FLASHING
or
If set to OFF, display will read:
DAY OF WEEK HOURS
FLASHING FLASHING
or
Display will scroll last service code event, date, time,
and temperature of when the event occurred.
for 3 seconds. Follow the prompts as outlined below.
MONTH DAY##
FLASHING
or
MINUTES AM/PM
FLASHING FLASHING
or
EXERCISE CYCLE OFF
MINUTES
FLASHING
or or
or
or
or
AM/PM
FLASHING
or
or
BRIGGSandSTRATTON.COM