Setup; Installing The Handle - Toro 22155 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Handle

Parts needed for this procedure:
2 Oval-head bolt (5/16 x 1-1/2 inches)
2
Bolt (5/16 x 1-1/2 inches)
2 Spacer
4 Locknut (5/16 inch)
1 Cable tie
Procedure
1. Remove the 2 screws that hold the back cover in place
and remove the back cover (Figure 3).
Description
Oval-head bolt (5/16 x 1-1/2 inches)
Bolt (5/16 x 1-1/2 inches)
Spacer
Locknut (5/16 inch)
Cable tie
SAE 30W detergent oil with an API
service classification of SH, SJ, SL, or
higher (not supplied with the machine).
No parts required
Figure 3
Qty.
2
2
2 Install the handle.
4
1
20 oz.
Fill the engine with oil.
(0.55 l)
–
Install the recycle plug or grass bag.
2. Attach the handle to the machine housing (Figure 4)
using the 4 bolts, 4 locknuts, and 2 spacers in the loose
parts bag.
1. Oval-head bolt (5/16 x
1-1/2 inches) (2)
2. Bolt (5/16 x 1-1/2 inches)
(2)
6
Use
Figure 4
3. Spacer (2)
4. Locknut (5/16 inch) (4)