Chapter 3: Configuration; Before Configuration - Atlantis Land A02-AP2-W54M Manual

Wireless mimo multi-function

Hide thumbs Also See for A02-AP2-W54M:

Table of Contents

CHAPTER 3: Configuration

The Wireless MIMO Multi-Function Access Point has a Web GUI interface for the

configuration. The AP can be configured through the Web Browser. A network

manager can manage, control and monitor the AP from the local LAN. This

section indicates how to configure the AP to enable its functions.

This section describes the configuration required by LAN-attached PCs that

communicate with the Wireless MIMO Multi-Function Access Point, either to

configure the device or for network access. These PCs must have an Ethernet

interface (or wireless adapter) installed properly, be connected to the Wireless

MIMO Multi-Function Access Point either directly or through an external repeater

hub or by wireless, and have TCP/IP installed and configured with a fixed IP

address that must be in the same subnet of the Wireless MIMO Multi-Function

Access Point. The default IP address of the Wireless MIMO Multi-Function

Access Point is 192.168.1.254 and subnet mask is 255.255.255.0.

Please follow the steps below for PC's network environment installation. First of

all, please check your PC's network components. The TCP/IP protocol stack and

Ethernet network adapter must be installed. If not, please refer to MS Windows

related manuals.

Wireless MIMO Multi-Function Access Point

Any TCP/IP capable workstation can be used to communicate

with or through the Wireless Access Point to configure other

types of workstations, please consult the manufacturer's

documentation.

A02-AP2-W54M

Pag. 9

Table of Contents