Drive Units; Connecting The Cables; Installing The Panels - JVC MC-8200LU Instructions Manual

7. DRIVE UNITS

CAUTION
• Make sure that the power is turned off when installing/removing, connecting or setting a drives.
Performing these operations while the power is on will result in the equipment malfunctioning.
Be sure to read the instruction manuals of the drive units before proceeding to any of the following work.
• Note that certain device drivers are incompatible with the simultaneous use of more than one type of drive (mixed use).
Please consult your dealer or nearest JVC service center.
7-1. Removing the panel
1.
Open the door.
( a See "5. Door Opening/Closing" on page E18.)
2.
Turn off the power.
3.
Remove the drive bay panel.
• Remove the 4 screws.
• Carefully disconnect the SCSI cable from the drive.
( a See "7-4 Connecting the cables" on page E23.)
• Unplug both the internal SCSI (SE) cable (50P cable)
and the LVD power cable (6P cable) from the connec-
tors on the SE-LVD conversion board.
7-2. Installing the drive units
• When removing the drive units, be sure to disconnect the control cable and power cable beforehand.
( a See "7-4. Connecting the cables" on page E23.)
1.
Inserting a drive unit.
• Always insert it into a bay with the lowest available
bay No.(from bottom to top)
• Be careful not to snag any cables.
• Be careful not to damage the sensor slit.
2.
Secure the drive using the provided metric screws.
• The provided metric screws are attached to the op-
tional drive unit.
CAUTION
Be sure to attach the screws securely. If the library sys-
tem is operated without the screws, either the library or
the drives may be damaged.
E22
Sensor slit
* Be careful not
to damage the
sensor slit.
A
A