Removing The Optional Carrier Transport Lock Screw; Installing Drives And Settings Scsi-Id No., Etc - JVC MC-8200LU Instructions Manual

3-4. Removing the optional carrier transport lock screw

When the MC-CF10U is installed, its special transport lock should be removed in addition to its being unlocked as
detailed in "3-2. Opening the transport lock" on page E11. Use the following procedure when unlocking the optional
carrier transport lock.
1.
Remove the transport lock
screw (for optional carrier).
2.
Insert the removed screw into the desigated storage hole for
the transport lock screw.
• If the system is transported with the MC-CF10U Optional Carrier installed, refer to "3-2. Opening the transport lock",
execute the packing mode and clamp the above-mentioned transport lock screw.

3-5. Installing drives and settings SCSI-ID No., etc.

1.
Installing drives
Install the drives ( a See "7. DRIVE UNITS" on page E22).
2.
Initial setting of SCSI-ID No., etc.
The default setting of the SCSI-ID No. of the MC-8200LU/8600LU is "0".
Set the SCSI-ID No. according to your system.
• To change the SCSI-ID No. of the MC-8200LU/8600LU a Read "8. SETTING THE SCSI-ID NUMBERS OF THE MAIN
UNIT" on page E26.
• To set the SCSI-ID Nos. and termination of drives a Read the instruction manuals of the installed drives.
• As the MC-8200LU/8600LU should be turned on to allow its SCSI-ID No. to be set, read "3-6. Connecting the power
cord and cables" on page E14 and connect the power cord before proceeding.
Setup
E13