Table of Contents
Advertisement
Connection to the L-2 IN connector with the SCART
cables
XV-DDV1SL
L-1
DVD/HDD
DVD
VIDEO
AUDIO
VIDEO SIGNAL
DVD DIGITAL OUT
OUT
OUT
SELECTOR
VIDEO
LEFT
PCM / STREAM
COAXIAL
OPTICAL
COMP.
L-2
Y / C
/ RGB
S-VIDEO
RIGHT
21-pin SCART
cables (not supplied)
VCR
The HDD deck is not compatible with RGB signal input. So
do not connect an RGB component to the L-2 IN connector
(or do not set the signal output mode of the connected
component to RGB signal).
When connecting the VCR to the L-1 IN/OUT
connector:
TV
DVD DIGITAL OUT
PCM / STREAM
COAXIAL
OPTICAL
S-video cable
(not supplied)
21-pin SCART
cables (not supplied)
S-Video cable connection is required only when the VCR is
not compatible with S-Video, but the TV is compatible.
Precaution before editing onto the HDD
The picture shown on the TV is a few seconds
behind the scene currently recorded onto the HDD.
Therefore, if you start recording at the desired scene
on the TV, you will miss the beginning of the scene by
a few seconds. On the other hand, when you stop
recording, you will record some extra scenes.
TV
IN/OUT
IN
SAT CONTROL
IN
OUT
AV
ANTENNA
COMPU LINK
XV-DDV1SL
DVD/HDD
DVD
L-1
IN/OUT
IN
VIDEO
AUDIO
VIDEO SIGNAL
OUT
OUT
SELECTOR
VIDEO
LEFT
SAT CONTROL
COMP.
L-2
IN
Y / C
/ RGB
OUT
AV
ANTENNA
COMPU LINK
S-VIDEO
RIGHT
VCR
To use the HDD deck for the recording component:
1
Make connections
Connect the VCR through the L-2 IN (or L-1 IN/OUT)
connector on the rear using the 21-pin SCART cable (not
supplied).
• When using the L-2 IN connector, set "L-2 SELECT" to
"A/V" (see page 68).
• If both the external VCR and the TV are compatible
with S-Video signal:
Set "L-1 OUTPUT" or "L-2 INPUT" to "S-VIDEO" (see
page 68).
2
Select the HDD deck.
On the remote control
Set the DVD/TV/HDD selector set to the right (HDD),
then press ENTER (or LIVE).
On the unit
Press DVD/HDD so that the HDD lamp lights.
3
Select the input mode on the HDD deck.
On the remote control
Press AUX (number button "0") and/or HDD/TV PR +/–
to select "L-2" for the L-2 IN connection, or "L-1" for the
L-1 IN/OUT connection.
On the unit
Press PR +/– to select "L-2" for the L-2 IN connection, or
"L-1" for the L-1 IN/OUT connection.
NOTE
When connecting a TV with TV-Link or with equivalent function
(see page 15) using the SCART cable, select "OFF" for "DIRECT
REC" (see page 67) in order to record S-Video signals through
the L-2 IN connector.
4
Start playback on the VCR.
• Refer to the instruction manual supplied with the VCR.
5
Start recording on the HDD deck.
On the remote control
¶
Press and hold REC
, then press
On the unit
¶
Press
(record).
¶
The lamp next to the
(record) button lights.
NOTE
For Y/C signal input/output, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.
85
3
.
Advertisement
Table of Contents
