Plumbed In Water Supply; Notes On Connecting To The Mains Water Supply; Connecting The Water Inlet Hose To The Coffee Machine - Miele CVA 5065 Operating And Installation Instructions

Plumbed in water supply

Notes on connecting to the
mains water supply
Connection to the mains water
supply should only be carried out by
a qualified and competent person in
strict accordance with national and
local safety regulations .
This machine conforms to IEC 61770
and ATS 5200.105.
The water quality must conform to
the requirements for drinking water
in the country the machine is being
installed in.
– All items used for connecting the
machine to the mains water supply
must comply with the current national
and local safety regulations in the
country in which the machine is
being installed.
– The machine is only suitable for
connection to the cold water supply.
– The machine is constructed to
comply with the relevant DIN stan-
dard and may be connected to the
mains drinking water supply without
a non-return valve if national
regulations permit.
– The flow pressure needs to be at
5
least 10 Pascal (1 bar). There is a
minimum flow pressure of 10
if 5 litres of water flow into a suitable
container in 15 seconds.
– The static water pressure must not
6
exceed 10 Pascal (10 bar).
72
– The stainless steel hose is 1.5 m
long. The hose may not be
lengthened as too much water would
then remain in the hose, adversely
affecting the quality of the coffee.
– A tap must be provided between the
stainless steel hose and the
household water supply to ensure
that the water supply can be
disconnected if necessary.
The tap should be easily accessible
after the machine has been built in.
Connecting the water inlet
hose to the coffee machine
^ Remove the cover cap from the
bottom of the back panel of the
machine. Connect the angled end of
the stainless steel hose to the
threaded connection of the machine.
Use the angled side of the stainless
steel hose.
^ Ensure that all connections are water
tight.
5
Pascal