Photo Mode; Wind Cut; Sound Mode - JVC GR-DVM5 Instructions Manual

36
EN

PHOTO MODE

SCENE
BEEP / TALLY

WIND CUT

SOUND MODE

ID NUMBER
DEMO. MODE
4
RETURN
PHOTO MODE
See pages 30 and 31.
SCENE (5-Second Mode) (
5S–Pressing START/STOP allows you to take a 5-
second "clip". Press repeatedly for a succession of
short recordings.
5SD–If you record a 5-second clip within 5 minutes
after the previous one, the end of the old scene
dissolves and is replaced by the new scene over a
2-second period.
ANIM. (Animation)–Each time you press START/
STOP, a 1/8-second recording is taken. By using an
inanimate object and changing its position between
shots, you can record the subject as though it's
moving.
• Animation is not available in the LP mode. If you
tried to record in the LP mode after setting ANIM.,
the recording mode indicator "LP" begins to blink,
and recording goes on in the SP mode.
NOTE:
During use of SCENE effect, focus (
exposure control (
operation.
BEEP/TALLY
The beep sounds when the power is turned on or
off, and at the beginning and end of recording.
Tally lamp lights up during recording.
ON–To activate the beep and tally lamp.
OFF–To turn off the beep and tally lamp.
FRAME
5S
ON
OFF
32kHz
06
OFF
pg. 28)
pg. 45) and
pg. 46) enter Full Auto
RECORDING
FRAME FULL
PIN-UP
5S 5SD ANIM.
ON OFF
OFF ON
32kHz 48kHz
This number is necessary when connecting
the camcorder to a computer [01 to 99].
OFF ON
WIND CUT
When activated, this mode helps cut down on noise
created by wind.
ON–When shooting in high winds, set to "ON" to
reduce noise.
•" " appears.
•The quality of the sound will change. This is normal.
OFF–This function is disabled.
NOTE:
The Wind Cut mode is disabled during Full Auto
operation.
SOUND MODE
Sound signals can be sampled at 32 kHz or 48 kHz.
32 kHz–This setting enables recording of stereo
sound on four separate channels, and is recom-
mended for use when performing Audio Dubbing
with another digital camcorder.
48 kHz–This setting enables recording of stereo
sound on two separate channels.
NOTE:
A tape recorded at 48 kHz cannot be used for
Audio Dubbing with another digital camcorder.
DEMO. MODE (Demonstration Mode)
This setting demonstrates certain functions such as
P.AE/Effects (
confirm how these functions operate. When the
camcorder is turned off, "DEMO. MODE" is set to
"OFF".
NOTE:
If a tape is in the camcorder, the Demo mode
cannot be turned on.
Advanced Features (Cont.)
MULTI 4 MULTI 9
pg. 44), etc., and can be used to