JVC GR-DVM5 Instructions Manual page 22

22
EN
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this proce-
dure.
Stop button
Play/Pause button
1 SELECT OPERATION MODE
Turn the Power Dial to "PLAY" while pressing
down the lock button located on the dial.
•The power lamp comes on.
2
PULL OUT VIEWFINDER OR OPEN
LCD MONITOR
Pull out the viewfinder fully or open the LCD
monitor to approx. 90 degrees.
3
START SEARCH
Press 6/4, then press 2 or 3. Watch in the
viewfinder or the LCD monitor for the spot
where you want to begin recording.
4 ENGAGE STILL MODE
Once you find the spot at which you want to
start recording, press 6/4 twice to engage the
Still mode.
Rewind button
Fast-forward button
RECORDING
5 START RECORDING
Turn the Power Dial to any operation mode
except "PLAY" and "OFF", then press START/
STOP.
•Start recording from a point prior to the end
of the last recording. A few seconds of the
end of the last recording will be erased.
NOTE:
Even if you start recording from the end of the
previous recording leaving no blank space, there
may be situations where a clean transition is not
possible.
Basic Recording (Cont.)
Power Dial
Power lamp
Lock button
START/STOP button