Preset Tuning - Panasonic SC-HT290 Operating Instructions Manual

A
C
1 3 2 4
A
MEMORY
B
D
CHANNEL
≥10/ENTER, 1–0
1
PRESET
2
TUNING
24
RQT5822
MEMORY
M
M
2 1
STOP PAUSE PLAY
SOUND MODE CHANNEL VOLUME MUTING
HELP SUBWOOFER
DIRECT TUNING/
TV VOL TV/VIDEO
DISC
1 2 3 DVD 6CH
4 5 6 DIGITAL
7 8 9
SFC
DISC/ ENTER
0 /ENTER
DECK 1/2 DELAY
PLAY MODE ACTION CANCEL LEVEL
The radio

Preset tuning

Choose either automatic presetting, which presets the stations the tun-
er can receive, or manual presetting, which allows you to select the
stations to preset and the order in which they are to be preset. There
are 30 channels available for presetting.
Remember
If a new station is preset into a channel, the old station is erased.
»
Automatic presetting
A
Presetting FM stations
Preparation: Tune to the FM frequency where you want to begin pre-
setting.
Press and hold [MEMORY].
The FM stations the unit can receive are preset in channels 1 to 30.
Presetting AM stations
Preparation: Tune to the AM frequency where you want presetting to
begin.
Press and hold [MEMORY].
The AM stations the unit can receive are preset in channels 21 to 30.
(FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator flashes and the fre-
quency scrolls. The memory indicator and channel numbers are dis-
played for a second when a station is preset ([B]).
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the power supply cord is disconnected from the household AC
outlet, the stations remain in memory for approximately one month.
»
C Manual presetting
Preset the stations one at a time.
Tune to the station.
Press [MEMORY].
! Press [TUNING X or W] to select a channel.
" Press [MEMORY].
»
Selecting channels
D
1
Press [PRESET].
The channel number flashes for about 5 seconds.
2
Press [TUNING X or W].
Hold down the buttons to change channels faster.
On the remote control
Press [CHANNEL X or W].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [L/ENTER], then the two digits.
e.g. To select channel 21 [L/ENTER]>[2]>[1]
MHz