Basic Steps - Panasonic SC-HT290 Operating Instructions Manual

1
3
1
POWER
2
DSP SOUND MODE SFC MODE
3
DSP SOUND MODE
4
SIZE, DISTANCE, D-INPUT
SFC MODE
FILTER, DR-COMP, DIMMER
INPUT SELECTOR
5
DSP SOUND MODE SFC MODE
42
RQT5822
2·5 4
4
INPUT SELECTOR
Receiver settings

Basic steps

If you allow about 10 seconds to elapse between settings, the proce-
dure is canceled, all settings are returned to how they were, and the
previous display is restored. Begin again if this occurs.
1
Press [POWER, ê/I].
2
Press [DSP SOUND MODE] and [SFC
MODE] at the same time.
3
Press [DSP SOUND MODE] to select
the item you want to change.
Each time you press the button:
SIZE>DISTANCE>FILTER>DR COMP
^---=DIMMER(-=D-INPUT(------}
4
Change the settings (á below).
Repeat steps 3 and 4 to complete the necessary
settings.
5
Press [DSP SOUND MODE] and [SFC
MODE] at the same time.
Changing the settings
SIZE
Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT_-)CENTER_-)SURROUND
^-=SUB-WFR (Subwoofer)(--}
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
FRONT:
CENTER and SURROUND: NONE()SMALL()LARGE
SUB-WFR:
! Repeat and
to change other SIZE settings.
DISTANCE
Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT>CENTER>SURROUND
^-------------------------------------------}
Turn [INPUT SELECTOR] to set the distance.
! Repeat and
to change other DISTANCE settings.
FILTER
Turn [INPUT SELECTOR] to set the cut-off.
When you turn the selector:
100()150()200
DR COMP
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF()STANDARD()MAX
D-INPUT
Press [SFC MODE] to select the input position you want to
set.
Each time you press the button:
CD COAX>DVD OPT2>TV OPT1
^-------------------------------------------}
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other corre-
sponding setting will also change.
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX()OPT1()OPT2
^-----------------------------------J
! Repeat and
to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF()ON
SMALL()LARGE
NO()YES