Removal 56 Operator Panel (Pl13.2.97) - Dell 3115cn Service Manual

Removal 56 OPERATOR PANEL (PL13.2.97)

Steps 1 through 8 are for reference. Before removing this component, check that Steps 1 through 8
have been performed.
1) Open the FRONT COVER (PL13.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 49)
4) Remove the COVER BOTTOM. (Removal 50)
5) Remove the COVER POLE IN R. (Removal 51)
6) Remove the COVER POLE R. (Removal 52)
7) Remove the RIGHT COVER. (Removal 54)
8) Remove the CHUTE ASSY EXIT OUT. (Removal 10)
10)-2
10)-1
11)
9) Remove the two screws (silver, tap, 10mm) that fix the OPERATOR PANEL (PL13.2.2) to the
FRONT COVER.
Take care not to move the OPERATOR PANEL away from the FRONT COVER too far
because the OPERATOR PANEL is secured to the HARNESS ASSY FRONT COVER.
When performing the step described below, take care not to drop or damage the
OPERATOR PANEL.
10) Remove the OPERATOR PANEL from the FRONT COVER by releasing the five hooks.
11) Disengage the connector of the OPERATOR PANEL (P/J202), and then remove the
OPERATOR PANEL.
Continues to the next page.
Version 2 2007.03.20
10)-1
10)-1
10)-1
Chapter 3 Removal and Replacement Procedures (RRPs)
10)-1
9)
3 - 81
9)
Gnb03161KA