Dell 3115cn Service Manual page 354

- Capability ECM
Sets whether or not to enable ECM.
0: Disabled, 1: Enabled.
- G3M V34 Bit Rate
Sets the signaling rate for the Super G3 (V34) mode.
The value can be set in the range of 2400bps to 33600bps in 14 steps. Below are the signaling
rates:
2400/4800/7200/9600/12000/14400/16800/19200/21600/24000/26400/28800/31200/33600
- Capability V34
Sets the communication capability of the Super G3 (V34) mode.
- G3M TX Coding
Sets the data encoding method for transmission. When the encoding method set here is not sup-
ported by the receiving side, the receiving side's method is adopted. Below are the encoding meth-
ods:
MH/MR/ MMR/JBIG
- G3M RX Cording
Sets the data encoding method for reception. Below are the encoding methods:
MH/MR/ MMR/JBIG
- G3M Baud rate Fix
Sets the signaling rate for transmission. Below are the signaling rates:
Disable/2400bps/4800bps/7200
Data signaling rate can also be set via G3M TX Modem Speed. When different rates are
set via G3M Baud rate Fix and G3M TM Modem Speed, the former takes precedence.
Version 1 2006.11.21
2 - 13
Chapter 2 Operation of Diag.