Table of Contents
Advertisement
WATER AND WASTE SYSTEMS
J - 1
GENERAL
All Four Winns® Vista models are equipped with a fresh
water supply system. This system consists of a water
supply tank, water distribution lines and a distribution
pump. The water fill deck plate for the fresh water sys-
tem is located on the starboard side of the deck, near
the stern, on the 248 Vista. The water fill for the 268
Vista is located on the port side of the deck, near the
stern. Always fill the tank slowly.
The water deck plate is appropriately labeled.
DO NOT fill the system with anything other than
water. Should the system become contaminated
with fuel or other toxic solution, component re-
placement may be necessary.
The water tank is equipped with an overboard vent. Main-
tain a close visual watch on the overboard vent while
filling the water tank. Always fill the tank slowly. When
the tank is almost full, water will spurt out of the vent.
NOTICE
When filling the tank, never seal the hose to the
deck plate. The tank will become pressurized
and could rupture.
DO NOT overfill the water tank. Tank damage
may result. Water capacity and tank location
may vary due to other equipment that may be
installed on the boat.
The capacity of the fresh water tank for the 248 and
268 is 20 gallons/75 liters. Optional tank level indica-
tors are available and if installed are located in the head.
See Figure J1 and J2 for the locations of the fresh wa-
ter tank and water heater. Access to the fresh water
tank and water heater is through the engine compart-
ment lids.
Vista 248/268 Owner's Manual
03/00
Figure J1: 248 Vista Water Tank/Water Heater Location
Figure J2: 268 Vista Water Tank/Water Heater Location
FRESH
WATER FILL
Section J
Page 1
Advertisement
Table of Contents
