Maintenance - Weider WEEVSY3426.1 User Manual

MAINTENANCE

Make sure that all parts are properly tightened each time you use the weight system. Replace any worn parts
immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not
use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the
weight pin into the middle of the weight stack. Slack can be removed from these cables several ways:
See drawing 1. Remove the M10 Locknut (56) and
the M10 x 55mm Bolt (66) from the Adjustable U-
bracket (45), the Cable Trap (51), the 90mm Pulley
(48), and the two Half Guards (43). Reattach the
Pulley, Cable Trap, and Half Guards to the next
closest hole to the center of the Adjustable U-
bracket. Make sure that the Cable Trap is
oriented to hold the cable in the groove of the
Pulley, that the Half Guards are oriented as
shown, and that the Cable and Pulley move
smoothly.
See drawing 2. Loosen the M12 Nut (86) on the
High Cable (55). Tighten the Cable into the Weight
Tube (24) until the slack is removed from the Cable.
Then, retighten the M12 Nut against the Large
Washer (87).
Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight
stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and
reinstall it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of
this manual.
1
66
51
2
55
87
27
56
43
43
45
48
86
24