Table of Contents
Advertisement
How to Use Auto Adjust
The Auto Adjust function is used during sound checks
to make adjustments for eliminating feedback. After
all equipment is connected, run the auto adjust
procedure during silent conditions (i.e., with no
sound entering the microphone).
Before beginning Auto Adjust, set the switches for
each function to the settings that will be used in
performance. For more information about each
function, please see "About the Function Setting
Switches" (page 13).
* Anti-feedback filter settings made during Auto Adjust
are preserved even after the power is turned off. Settings
are recalled when the power is turned back on.
* Do not talk into the microphone during Auto Adjust.
1.
Turn the microphone switch to "On," set mixer,
power amp, and other equipment levels, then
bring up the microphone volume until the desired
level is reached.
2.
Press the [START] button. The Auto indicator
flashes, and Auto Adjust begins operation.
Flashing
3.
Auto Adjust ends automatically after securing a
safety margin of approximately 12 dB. The Auto
indicator stops flashing and instead will light
steadily. The anti-feedback filter settings are fixed.
At this point, feedback adjustments made with
Auto Adjust are complete.
Lit
* Once all twelve anti-feedback filters are set, Auto Adjust
automatically ends (regardless of the safety margin), and
the anti-feedback filter settings are fixed (see "About the
Safety Margin" on page 12).
Stopping Auto Adjust While in
Progress
Press the [SET] button. The Auto indicator light goes
on, and anti-feedback filter settings made up to that
point are set.
Continuing/Resuming Auto
Adjust
Press the [START] button. Auto Adjust resumes, using
settings made up to the point of cancellation.
Canceling the Anti-Feedback
Filter
Hold down the [CLEAR] button for approximately
two seconds. The Auto Indicator light goes off, and all
anti-feedback filters are cleared.
Restarting Auto Adjust From the
Beginning
2
First hold down the [CLEAR] button; this clears filters
that have been set. Then press the [START] button to
run Auto Adjust.
1
11
Advertisement
Table of Contents
