Table of Contents
Advertisement
Panel Descriptions
Front Panel
PEAK Indicator
POWER Indicator
With an AC adaptor connected, this indicator lights
up when the power is on.
PEAK Indicator
This indicator lights during high input signal levels.
The indicator lights up at 6 dB below the level where
distortion begins. If the indicator seems to be lighting
up too frequently, flip the input level switch on the
rear panel.
AUTO Indicator
This indicates the operating status of the Auto Adjust
function.
Lit:
Auto Adjust is completed, and the anti-
feedback filters are set.
Flashing: Auto Adjust is in progress.
Off:
No anti-feedback filters are set.
POWER Indicator
Auto Control Buttons
AUTO Indicator
LOCK Switch
Function Setting Switches
Auto Control Buttons ([START] [SET] [CLEAR])
Pressing the [START] button initiates Auto Adjust.
Pressing the [SET] button ends the Auto Adjust process,
and fixes the anti-feedback filter settings.
Holding down the [CLEAR] button for approximately
two seconds completely clears the anti-feedback
filters.
For more information about Auto Adjust function,
please refer to "About Auto Adjust" on page 10.
LOCK Switch
With the lock function set to "ON," even if the
[START], [SET], or [CLEAR] buttons should happen to
be pressed, Auto Adjust will not operate (for more on
the lock functions see page 12).
Function Setting Switches
These switches turn on and off each of the following
functions: Filter Wide, Dynamic, Diffuse, Limiter,
Enhancer, Low-Cut Filter, and Hi-Cut Filter. For more
information about each of these functions, please
refer to "About the Function Setting Switches" on
page 13.
* When altering settings, use a ball-point pen or similar
object. Do not apply excessive force to the switches, as
this may damage the unit.
* The fourth switch from the left is not assigned to any
function. Moving this switch has no effect on any
operation.
7
Advertisement
Table of Contents
