Blow Function Setting - Fisher FSPI-091B Operating And Installation Instruction Manual

DC Inverter Floor Ceiling Type Air Conditioner Installation and Operation Manual
(continued)
Note:
E-HEATER can not be set in cooling, dry and fan mode, E-HEATER mark won't be displayed. The setting
is shown in Fig.16.

4.12 Blow Function Setting

BLOW function: After the unit is turned off, water in evaporator of indoor unit will be automatically
evaporated to avoid mildew.
In cooling and dry mode, press Function button till the unit enters BLOW function, with BLOW blinking,
and then press Enter/Cancel button to turn on this function.
In BLOW mode, press Function button till the unit enters BLOW function and then press Enter/Cancel
button to cancel this function.
BLOW function setting is shown in Fig.17:
Fig.16 Auxiliary Electric Heating Function Setting
18