Rip Controller Card Removal; Paper Face Up/Face Down (Fud) Delivery Sensor Removal - Lexmark Optra Color 1200 Service Manual

5050-001

RIP Controller Card Removal

1. Be sure the printer power is off and the power cord is
unplugged.
2. If the rear output bin is attached to the back of the printer, lift it
straight up and remove it from the printer.
3. Disconnect all cables from the back of the printer.
4. Loosen the six thumbscrews on the system board faceplate at
the back of the printer.
5. Slide the system board completely out of the printer and place it
on a level surface.
Paper Face Up/Face Down (FUD) Delivery Sensor
Removal
1. Remove the rear cover.
2. Remove the connector.
3. Remove the photo interrupter.
4. Be sure to check the actuator after you reassemble.
Repair Information
4-61