Lexmark Optra Color 1200 Service Manual page 61

5050-001
Message
84 Color PC Drums
Exhausted
84 color PC
Abnormal
88 color Toner Low
2-22
Service Manual
Action
The three color photoconductors have reached the
end of their 13,000-page life. You may want to replace
the photoconductors now. When you do replace them,
replace all three—cyan, magenta, and yellow—at the
same time.
If the print quality is still acceptable, press
the message and continue printing. The
status message is then displayed with the
,
Power Saver Busy
another status message of higher priority is posted—
until you replace the photoconductors.
If this message does not reset after replacing all
photoconductor units, clean or replace the drum
sensor (11G0548) in the right sub frame.
You have installed a defective photoconductor. You
must replace the specified photoconductor before you
can continue printing.
If this message does not reset after replacing all
photoconductor units, clean or replace the drum
sensor (11G0548) in the right sub frame.
The printer has detected that the toner supply in the
specified cartridge is low. After printing approximately
250 more pages, the printer will display the
message and cease operating until the
Toner Empty
toner cartridge is replaced. If you do not have the
necessary supplies, order them now.
Press to clear the message. The
Go
message is then displayed with the
, and
Saver Busy
status message of higher priority is posted—until you
replace the toner cartridge. The
message is also displayed each time you turn the
printer on and each time you open and close the top
cover.
If this message does not reset after you replace all the
toner cartridges, clean or replace the toner remaining
sensor (11G0207) in the right sub-frame.
and messages—unless
Waiting
messages—unless another
Waiting
88 color Toner Low
to clear
Go
Supplies
,
Ready
88 color
status
Supplies
,
Ready Power