JRC NCR-333 Instruction Manual page 44

f. Output the message from an external port
The data of currently opened message text can be
output to the connected the external equipment (ECDIS,
etc).
Procedures
1) Press the * key. The sub screen appears.
2) Select the "[DATA OUT]", and press the ENT key.
3) Select the port which outputs message data.
- SEL-DATA OUT: The message data is outputted
- SEL- DISP OUT: The message data is outputted
4) "ARE YOU SURE?" is displayed. Select the "[OK]",
and press the ENT key. ("NOW OUTPUTTING..." is
displayed on the sub screen.)
To return to the sub screen (SET UP), select
"[CANCEL]" and press the ENT key.
5) After message outputting has been completed,
press the ENT key or the CLR key.
Notes
- To stop outputting, press the CLR key while outputting.
6-12
from a "DATA OUT" port.
from a "DISP" port.
IA01 518 15
JAPAN NAVTEX N.W. NR 1260/2005
KEIHIN KO, TOKYO EAST PASSAGE.
DAYTIME DAILY UNTIL 08 JULY 2006
.
AREA BOUDED BY
35-35-37.9N 139-47-18.4E * SET UP *
35-34-58.9N 139-48-08.6E [NEXT
35-34-53.9N 139-48-03.1E [PREV. MSG]
[SAVE
35-35-02.0N 139-47-55.3E
35-35-32.3N 139-47-16.6E [PRINT OUT]
35-35-35.0N 139-47-15.1E DATA
35-33-37.9N 139-46-18.4E
35-33-58.9N 139-46-16.6E
35-33-32.3 N 139-45-16.6E
35-35-35.0N 139-44-15.1E, WGS-84
. *DATA OUT*
LINE: 10/ 18 [SEL-ECDIS OUT]
[SEL-DISP
[CANCEL]
*DATA OUT*
ARE YOU SURE?
[OK]
*DATA OUT*
DATA OUT OK
[OK]
31/12/05 18:20
MSG]
MSG]
OUT
OUT]
[CANCEL]
[CANCEL]