Vivotek VS8801 User Manual page 9

Below are the definitions for other combinations of LEDs:
Item LED status
1 Blinking Green every 2 sec.
Blinking Red every 0.15 sec. + Blinking Green every
2
1 sec.
Blinking Red every 0.15 sec. + Blinking Green every
3
0.15 sec.
Hardware Reset
■ VS8801
■ VS8401
USB & SD card
functions
are not available
on this unit.
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the video server to normal operation. If the system problems
remain after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button using a straightened paper clip. Wait for the
video server to reboot.
Restore: Press and hold the reset button down until the status LED rapidly blinks. It takes about
30 seconds. Note that all settings will be restored to factory default. Upon successful restore,
the status LED will blink green and red during normal operation.
Recessed Reset Button
Recessed Reset Button
Description
Audio mute (heartbeat)
Upgrading Firmware
Restoring default
USB & SD card
functions
are not available
on this unit.
USB function
is not available
on this unit.
VIVOTEK
USB function
is not available
on this unit.
User's Manual - 9