Table of Contents
Advertisement
Most scanners shipped from the factory are set to read variable length labels for
Codabar. If you switch from variable to fixed length labels, the factory set fixed label
lengths are 14 and 08. Follow the steps below to change these defaults.
Enable Fixed
1.
Identify the fixed length settings you want to make.
2.
Scan the SET label.
3.
Scan the SET FIRST FIXED LENGTH label.
Setting Lengths
If you are setting a length less than ten, you must scan a zero first and then the length
digit (02, ...09).
4.
Set the first fixed length label by scanning the correct digits from the
next page. The selectable range is from 03 to 50 digits
If you need to set a second fixed length, continue with step five. If you
do not need to set a second fixed length, scan the NO SECOND
FIXED LENGTH label below and skip to step seven.
SET --------------------------------------------------
S
ET
1
The scanner will decode up to 50 characters, but the actual length read will vary
depending upon bar code size and quality. The IBM POS interface is limited to 32
character labels.
74
Codabar Fixed Length
S
F
L
ECOND
IXED
ENGTH
-------- S
-------- N
QuickScan™ 1000 Programming Guide
1
.
F
F
L
ET
IRST
IXED
S
F
O
ECOND
IXED
ENGTH
L
ENGTH
Advertisement
Table of Contents
