Table of Contents
Advertisement
Where To Go From Here
Programming is easy and straightforward if you follow these steps:
1.
If you are changing interfaces, first connect the scanner to the new host
using the new interface cable. Scan the interface enable bar code label
2.
Scan any feature labels that are unique to the interface you are currently
programming. These interface specific programming labels immedi-
ately follow each interface selection label.
3.
Turn to the Symbology section if you are going to change any bar code
symbologies or modify any symbology related features.
4.
Turn to the General Features section of this guide if you wish to
change or modify any of the scanner's other features.
Once the necessary changes have been made, and you have scanned the END label,
you are ready to scan.
1
This step is not neccessary for QuickScan 1000 scanners, unless you require a
specific interface sub-type such as SNI or IBM sub-type 4682/92 Port E. Interface
software is automatically selected when the QuickScan 1000 hardware connection
(via a new interface cable) is made.
8
QuickScan ™ 1000 Programming Guide
1
.
Advertisement
Table of Contents
