Table of Contents
Advertisement
Changing Interfaces
To change a scanner's interface...
If necessary, replace the scanner's interface cable to match the new host terminal's
connection requirements. To disconnect the cable from the scanner, insert a .050" hex
driver or bent paper clip into the CABLE RELEASE hole, and press down to unlock
the cable connector. Reference Figure 1.
We recommend that you disconnect power before plugging/
unplugging cables to avoid any possibility of equipment damage.
1.
Verify that your scanner supports the desired interface
indicates interfaces available at the time of this writing. Your scanner comes
equipped from the factory with the ability to connect and communicate with
at least two major interface types, for example, Keyboard Wedge/RS-232
and Keyboard Wedge/Wand Emulation are two common pairings.
Contact your nearest PSC service depot if you don't know your scanner's
interface group, or need to have the scanner altered to change to another I/F
group.
1
Contact your dealer if your desired interface is not listed. Interface group definitions
are subject to change without notice.
2
Figure 1. Disconnecting the Interface Cable
HARDWARE
NOTE
SOFTWARE
QuickScan ™ 1000 Programming Guide
1
. The list below
Advertisement
Table of Contents
