Table of Contents
Advertisement
This section describes how to set the scanner's programmable features.
These features can be configured using the bar code labels contained in this
manual or by using commands sent from the host. Refer to Appendix A,
Additional Information, for host programming details. If you program the
scanner using these bar codes, the scanner stores the changes until repro-
grammed.
What Is Programming Mode?
To change the scanner's programmed settings, it is necessary to place the scanner in
Programming Mode using the special SET label. This ensures that the scanner only
recognizes the special programming labels contained in this programming guide.
How To Program Using Bar Codes
The following pages contain special bar code labels that are used to
change or enable the scanner's programmable options. All programming
sessions follow this order, unless otherwise instructed:
1.
Scan the SET label at the top of the page. The scanner will emit a
'good read' beep, indicating it has read the label.
2.
Scan the feature label(s) for the programmable options you wish
to enable. With few exceptions
each time you scan a valid programming label. (Note that not all
features are available for all interfaces and that the scanner will sound an
error tone when scanning programming labels for features invalid to
the current interface.)
3.
Scan the END label at the bottom of the page to complete the
programming session and exit Programming Mode. The scanner will
sound one 'good read' beep upon exiting Programming Mode.
4.
It is strongly recommended that you Maintain a good record of all
changes made to ensure that you know if the original factory settings
have been changed.
1
Some features, such as Minimum Label Length or Label ID, require you to select the
length by scanning a series of single-digit bar codes. A single 'good read' beep is
sounded when scanning these single digits in Programming Mode. Only the final
required digit in the sequence will produce a triple beep when scanned, indicating a
successfully programmed feature.
R44-2018
Programming Overview
1
, the scanner will emit a triple beep
5
Advertisement
Table of Contents
