Table of Contents
Advertisement
Setting A Single Character Prefix or Suffix
To set one ASCII character as a prefix or suffix, follow steps one through four on the
previous two pages (select prefix or suffix), then...
1.
Scan the two digit Hex Code for that character.
(e.g. 03, 8F, ...FF)
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone (six rapid beeps) to indicate that programming
was incomplete, and the setting will remain as it was before entering
Programming Mode.
2.
Scan the ONE CHARACTER ONLY label on the following page.
3.
Scan the END label.
You have set a single character prefix or suffix.
Setting Prefix and/or Suffix Characters
You must scan the SET label and either the Set Prefix or Set Suffix
label before using the labels on this page.
1 ------------------------------
3 ------------------------------
5 ------------------------------
R44-2018
NOTE
NOTE
-------- 0
-------- 2
-------- 4
35
Advertisement
Table of Contents
