Recycle Feature; Hot Tub Flag - Fisher & Paykel PHASE 6 Series 11 Service Manual

517766
1. If a fault occurs in the machine, the diagnostic system will detect it. However,
instead of displaying a fault code immediately, the machine will try to RESTART.
2. If the fault was only of a temporary nature, the machine will restart and finish the
cycle.
3. If there is a continuous fault the machine will try to RESTART a number of times.
This process could take up to 8 minutes depending on the type of fault. After this, if
the machine still cannot restart, the fault code is displayed and the machine will
beep continuously.
NOTE - This feature is designed as a service aid only and should be left ON in the
customer's home. To return to normal operation, and to reset the RESTART feature to
the factory setting, switch the machine off at the wall or disconnect from the mains supply.
16.7

Recycle Feature

At the end of servicing, the machine may require an extended test where the machine can
be left to complete a number of wash cycles. By turning on the RECYCLE feature the
machine will continuously repeat the wash cycle until the RECYCLE feature is turned off.
Whether or not the RECYCLE feature is on is indicated during normal use of the machine
as follows:
When the machine is first turned on:
1. If none of the 3 right most wash progress LED's are on, the recycle feature is
off.
2. If all 3 of the right most wash progress LED's flash, the recycle feature is on and
smart drive will continuously recycle.
NOTE - This feature is designed as a service aid only and should be OFF in the
customer's home. To return to normal operation, and to return the recycle feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
16.8

Hot Tub Flag

If the machine has been filled with the hot water valve utilised (ie. warm or hot fill) and has
not had a cold rinse, the electronics will not allow the machine to spin up to its full speed
of 1000 RPM. It will only allow the spin speed to reach 700 RPM.
To allow the machine to spin up to 1000 rpm, restart the machine at cold rinse and this will
reset the Tub flag detecting.
The Softener Rinse LED will be on when the Diagnostic Mode is selected if the spin
speed is restricted to 700 rpm. To clear this flag press the Wash Option button below the
Softener Rinse LED.
NOTE: The drain pump test, water valve test, restart, recycle and hot tub flag features
can be accessed from any level in the diagnostic mode.
- 20 -
March 2003