Using The Single User Function; Using The Spi Function - Samsung AR**FS**WK** Series User & Installation Manual

Using the Single User function

This function will reduce the energy usage while the air conditioner is operating in Cool/Heat mode.

Using the SPi function

This function will produce positive ions and supply them into the airflow. (Applicable model: ARWKSeries)
Australia_A3050_IB&IM_EN_03979A-03.indd 23
Press the Single User button on the remote controller while the air conditioner is
operating in Cool/Heat mode.
" " appears on the remote controller display for few seconds and

disappears.
S ingle User indicator and air swing(

controller display.
The air flow blades move up and down.
I f the current set temperature is lower than 24°C in Cool mode, it will be automatically

raised to 24 °C.
Press the Single User button once again.
Cancel
• Single User function is only available in Cool/Heat mode.
• W hen Single User function is activated in Cool mode, temperature range will
be limited to 24 °C~30 °C. However, temperature range during Heat mode will
remain same at 16 °C~30 °C.
• I f the desired temperature is lower than 24 °C in Cool mode, turn off the Single
User function by pressing the Single User button again.
• T emperature/Fan speed can also be adjusted (see page 17 for instructions).
• Air flow can be adjusted. (see page 18 for instruction).
• I f you press the Mode button while the Single User function is on, it will cancel
the function.
Press the button on the remote controller.
indicator will appear on the remote controller display and the air conditioner

generates SPi.
S Pi Lamp on the indoor unit will turn on when the SPi function is on and it will turn

off when the function is canceled.
Cancel
Press the button once again.
• T he SPi function can be selected whether the air conditioner is on/off.
• T he SPi function may not be available for some models.
English-23
) indicator appear automatically on the remote
2013-10-26 16:58:08