Inputs And Outputs - Extron electronics XTP CrossPoint 1600 Setup Manual

Inputs and Outputs

a
Input boards space
as desired.
XTP CP 4i (XTP input board)
IN
SIG LINK SIG LINK SIG LINK
PWR PWR PWR
XTP LAN XTP LAN XTP LAN
1b 1a 1c 1b 1a 1c 1b 1a 1c
XTP input connectors — Connect a TP cable
1a
between a compatible Extron XTP transmitter and
this connector (see
wire the connectors).
ATTENTION: Do not connect this device to a computer data
or telecommunications network.
XTP Power indicators — Light or blink to indicate the status
1b
of the power over XTP that the input board is providing to the
transmitter endpoint as follows:
Lit green — The board is providing XTP power to the endpoint.
Lit amber — XTP Power is available for the endpoint, but it is
disabled in the matrix switcher.
Flashing amber — No XTP power is available for the endpoint,
but it is enabled in the matrix switcher.
Lit red — A wiring fault exists.
Unlit — The endpoint is not capable of receiving power over XTP.
LAN connectors — As desired, connect a TP cable
1c
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see
connectors on page 12 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
1d
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR communications on
the associated inputs. (see
page 13 to wire the connectors).
6 XTP CrossPoint 1600 and 3200 • Installation
—
Make connections to installed input boards
SIG LINK
IR/RS-232 OVER XTP
RS-232 IR RS-232 IR RS-232 IR RS-232 IR
PWR
XTP LAN Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx
1b 1a 1c 1d
SIG
PWR
TP connectors on page 12 to
XTP
TP
RS-232
Tx Rx
RS-232 and IR connectors on
XTP CP 4i REMOTE
RS 232/RS422
4
ACT
3
LAN
LINK
5
LINK
RESET
100-240V --A MAX
6
50-60Hz
DISCONNECT POWER
CORD BEFORE
SERVICING
IN
1e
LAN
IR
Tx Rx
1
O
I
U
N
T
P
P
U
U
T
T
S
S
Figure 3. Active Portion of XTP CrossPoint 3200 Switcher Rear Panel
XTP CP 4i HDMI (HDMI input board)
1e 1e 1e
HDMI connectors — Connect up to four HDMI cables
1e
between these ports and the HDMI output port of the
digital video sources.
NOTE: See HDMI connectors
connector to the board with a LockIt HDMI Cable Lacing
Bracket.
Audio (local audio) connectors — Connect
1f
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see
audio connectors on page 15 to wire the connectors).
XTP CrossPoint 1600 and 3200 • Installation
2
XTP CP 4i HDMI
AUDIO
L R L R L R L R
1f
on page 14 to secure the
L R
Local
7