Shaving; Trimming; Cleaning; E Troubleshooting - Remington HyperFLEX XR1330 User Manual

C geTTINg STARTed

For best shaving performance, it is recommended that you use your new shaver daily for
up to four weeks to allow time for your beard and skin to become accustomed to the new
shaving system.
, CHARgINg yOuR SHAVeR
• Ensure the appliance is turned off.
• Connect the charging stand to the adaptor and then to the mains.
• Place the shaver in the charging stand.
• Charge for at least 24 hours when using for the first time.
• Allow 90 minutes for a full charge. The charging indicator light (XR1330), fuel gauge
(XR1350) or LED display (XR1370) will indicate when the shaver is fully charged.
• To preserve the life of your batteries, let them run out every 6 months then recharge for
24 hours.
• The shaver automatically adjusts to a mains voltage between 100V and 240V.
O This appliance should be charged by approved safety isolating adaptors PA-0510E(K)
with the output capacity of 5.0 dc; 1.0A.
C HOW TO uSe

, SHAVINg

Note: This shaver is for cordless use only.
• Make sure your shaver is properly charged.
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright
• Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
, SHAVINg WITH SHAVINg geL
• Follow the same instructions as dry shaving if using with gel.
F CAuTION: After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.

, TRIMMINg

• Push the trimmer button to release the detail trimmer.
• Hold the trimmer at right angles to the skin.
• Place the trimmer at desired trim line for a quick, easy, professional trim.
• To retract and switch off the trimmer, push the trimmer down and lock into place.
4
E Tips for best results
Use moderate to slow stroking movements. The use of short circular motions in stubborn
areas may obtain a closer shave, especially along the neck and chin line.
dO NOT press hard against the skin in order to avoid damage to the rotary heads.
C CARe fOR yOuR SHAVeR
Care for your appliance to ensure a long lasting performance. We recommend you clean your
appliance after each use. The easiest and the most hygienic way to clean the appliance is by
rinsing the appliance head after use with warm water.

, CLeANINg

• Ensure the shaver is switched off.
• Hold the head and gently pull up on the ribbed area to remove the hairpocket from
the head.
• Slide the cutter locking mechanism to remove the cutters.
• Tap out excess hair shavings and use a cleaning brush if necessary.
• Close head assembly.
, CLeANINg TRIMMeR
• Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
Replacement parts and accessories available to buy at www.remington.co.uk/
parts-accessories.

E TROuBLeSHOOTINg

If your shaver battery is completely empty or the shaver has not been used for an extended
period of time, the shaver may not start when operated using the cord. If this occurs, charge
the shaver for approximately 15 sec. before shaving.
H eNVIRONMeNTAL PROTeCTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol must not be disposed of
with unsorted municipal waste, but recovered, reused or recycled.
5