Shaving Tips; Cleaning And Maintenance - Remington X-SYSTEM PRECISION R3151AU Use & Care Manual

SHAVING TIPS

• Always hold the shaver at a right angle to the skin so that all three heads are touching the
skin with equal pressure
• Stretch skin with the free hand so hairs stand upright, making it easier for them to enter the
cutting chamber.
• Use moderate to slow, circular stroking movement. The use of short, circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads.
• As with every shaver, your shave will improve over time. Allow up to four weeks of daily
shaving to develop effective shaving style and for your skin to adjust to the new shaver. The
adaptation period my take a little longer if your skin is sensitive, if you are switching from a
different method of shaving, or if you alternate between shaving methods.
CLEANING & MAINTENANCE
DAILY CLEANING
1. Open the shaver head by pressing the release button on the front of the shaver (Fig. A) and
flipping open the head away from the body of the shaver (Fig. B).
2. Tap out excess hair shavings.
3. Close the head assembly (Fig. C).
MONTHLY CLEANING
1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hair pocket assembly. (Diagram D) Place the body of the shaver
aside to ensure that it will not get wet.
3. Place a drop of liquid soap on each cutter. (Diagram E)
4. Brush the soap around vigorously using the supplied cleaning brush. (Diagram F)
5. Release the inner cutter carrier by rotating the locking arms counter-clockwise. (Diagram G)
6. Remove the inner cutter carrier away from the cutters. (Diagram H)
7. Remove the cutters. (Diagram I)
8. Thoroughly brush any hair off of the inner and outer cutters (Diagram J) and rinse away any
soap and debris from inner and outer cutters. (Diagram K)
9. Replace the inner cutters. (Diagram L)
10. Place the inner cutter carrier back into position and lock into place by rotating the locking
arms clockwise until they snap into place. (Diagram M)
11. Lubricate each cutter with household oil.
12. Close the head assembly. (Diagram C)
WARNING:
• Only the detachable shaving head can be rinsed with water.
• DO NOT rinse the hand-held shaver under water as damage will occur.
4