Jam At Exit; Open Rear/Top Cover To Clear - Xerox Phaser 4500 Service Manual

Jam At Exit; Open Rear/Top Cover To Clear

Error Codes
E4-0
E4-2
E4-3
Troubleshooting Reference
Applicable Parts
Fuser Assembly
HVPS/Engine Logic Board
Fuser Assembly Harness
Exit Motor Assembly
LVPS
Exit Pinch Roller
Exit Assembly
150-Sheet Paper Cassette
550-Sheet Paper Cassette
Troubleshooting Procedure
Steps Actions and Questions
1 Check the condition of the paper in the tray.
Is the paper crumpled, damaged, damp,
or out of specification?
2 Check the paper size setup.
Does the paper size in use match the
size setup by the End Guide or by the
driver on the PC?
3 Does the error occur when the power is
turned ON?
4
Check for paper in the Fuser at the Exit
Sensor Actuator.
Is there any remaining paper in the
Fuser?
5
Does the error occur when the power is
turned ON?
6 Enter Service Diagnostics, and from the
Engine Test Print
Pattern.
Does the error occur?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Fuser Assembly, Power Switch" on page 10-20
"24 V Interlock, Rear Cover Switch, Main Motor, Sub
Fan, Exit Motor Assembly" on page 10-18
"150-Sheet Feeder, 550-Sheet Feeder, Main Fan"
on page 10-22
"Print Engine General Wiring Diagram" on
page 10-17
"Print Engine Plug/Jack Locator" on page 10-3
menu select Print Test
Yes
Replace the
paper.
Go to step 3.
Go to step 4.
Remove the
paper, and go to
step 5.
Go to step 8.
Go to step 7.
No
Go to step 2.
Replace the
paper, or set up
the paper size
correctly.
Go to step 6.
Go to step 8.
Go to step 6.
Problem solved.
3-41