Removing The Oven Burner & Ignitor - Whirlpool SF3000SE W Service Manual

REMOVING THE OVEN BURNER & IGNITOR
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electrical
shock.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
1. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
2. Remove the oven door (see page 1-24 for the
procedure).
3. Remove the racks from the oven.
4. Remove the two screws from the oven floor
and remove it.
REMOVE
SCREWS
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
5. Remove the heat shield from the oven .
REMOVE SCREWS
6. Remove the front and back mounting screws
from the oven burner.
OVEN BURNER
MOUNTING
SCREW
7. Disconnect the ignitor's quick-disconnect plug
from the main harness.
8. Remove the oven burner and ignitor assem-
bly from the oven.
9. Reinstall the new oven burner and ignitor
assembly and reassemble the range.
3-21
4321890
Page 3-21
OVEN LINER
MOUNTING
SCREW
BRACKET
IGNITOR
QUICK-DISCONNECT
BACK OF
MOUNTING
SCREWS
HOLE IN
BOTTOM LINER
PLUGS