Autopage C3-RS-625 Installation Manual page 22

NOTE: Before an attempt to remote start, the unit must be programmed for a
system type, Tachometer Check, Voltage Check or Timer Check.
If none of the check types have been programmed, The Remote start will have
not function properly
FEATURE "C" PROGRAMMING:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 7 times (holding in on the 7th push) until three
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'C' programming mode.
Press and release the transmitter button corresponding to the feature you
want to program.
Press One Chirp /
Transmitter LED one pulse
Button Factory
Default
Setting
3 Hours Timer
1
Start
Gasoline
2
Engine
20 minutes run
3
time
Factory alarm
disarm
4
channel 2 on
Constant
parking
5 +
output upon
Remote Start
REMOTE START FEATURE PROGRAMMING:
Two Chirps /
LED two pulse
2 Hours Timer
Start
Diesel Engine
Wait-To-Start
Light
10
warm-up
30 minutes run
time
Without
with
feature
Flashing parking
light
light output upon
Remote Start
Three Chirps /
LED
pulse
Diesel Engine
Wait-To-Start
Light
sec 15
warm-up
10 minutes run
time
this
22
Four Chirps /
three LED four pulse
Diesel Engine
Wait-To-Start
Light
sec 20
warm-up
5 minutes run
time
sec