Ryan Tcad Config Page; Gad 42 Config Page; Gdl Config Page; Figure 5-28. Ryan Tcad Config Page - Garmin GPS 400W Installation Manual

5.3.21 RYAN TCAD CONFIG Page

Select the RYAN TCAD CONFIG Page
(see Figure 5-28). This page shows the TCAD's current
shield settings for the selected mode, approach mode
status, volume, mute status, mute duration, voice alert
selection, and system status.
Verify that the TCAD system status is GREEN. Also,
verify that shield settings and volume, mute duration, and
voice alert selection can be modified. Verify that
changes in mute (if a mute switch is installed) are shown.
Refer to the Ryan TCAD installation manual for system
checkout.

5.3.22 GAD 42 CONFIG Page

The following page is only available if a ARINC 429
input is configured for the GAD 42.
Select the GAD 42 CONFIG Page (see Figure 5-29).
This page allows remote configuration of a GAD 42
Interface Adapter Unit. For details of this function,
please refer to Section 5 of the GAD 42 Installation
Manual (P/N 190-00159-00).

5.3.23 GDL CONFIG Page

This page allows the user to set the attenuation and model
of the GDL 69. It is only available if one of the RS-232
ports is configured for the GDL 69/69A.
The GDL 69A XM must be activated before use. If the
XM activation has not already been done, see the
GDL 69/69A Installation Manual (190-00355-02) and the
GDL 69/69A XM Activation Instructions
(190-00355-04).
Selection Description
Sets the attenuation value for the GDL 69/69A. Refer to the GDL 69/69A Installation
Attenuation
manual (190-00355-02) to determine the correct attenuation value.
Model Sets the model to either GDL 69 (weather only) or GDL 69A (weather and audio).
GNS 400W Series Installation Manual
190-00356-08

Figure 5-28. RYAN TCAD CONFIG Page

Figure 5-29. GAD 42 CONFIG Page

Figure 5-30. GDL CONFIG Page

Page 5-25
Rev. G