Figure 5-19. Ryan Tcad Config Page; Figure 5-20. Gad 42 Config Page; Figure 5-21. Data Link Page - Garmin GPS GNS 530 Installation Manual

5.2.17 RYAN TCAD CONFIG Page
(Only if 500 Series unit configured for Ryan TCAD
interface)
Select the RYAN TCAD CONFIG Page (see Figure 5-19).
This page shows the TCAD's current shield settings for the
selected mode, approach mode status, volume, mute status,
mute duration, voice alert selection, and system status.
Verify that the TCAD system status is GREEN. Also,
verify that shield settings and volume, mute duration, and
voice alert selection can be modified. Verify that changes
in mute (if a mute switch is installed) are shown. Refer to
Figure 5-19. RYAN TCAD CONFIG
the Ryan TCAD installation manual for system checkout.
Page
5.2.18 GAD 42 CONFIG Page
(Only if 500 Series unit configured for GAD 42
interface)
Select the GAD 42 CONFIG Page (see Figure 5-20). This
page allows remote configuration of a GAD 42 Interface
Adapter Unit. For details of this function, please refer to
Section 5 of the GAD 42 Installation Manual (P/N
190-00159-00).

Figure 5-20. GAD 42 CONFIG Page

5.2.19 MONITORING THE DATA LINK
The Data Link is monitored on the Data Link Page. There
are four main page groups in the 500 Series software
version 2.10 or higher: NAV, WPT, AUX, and NRST (see
the 500 Series Pilot's Guide for detailed information on the
unit's Page Groups). The Data Link Page (Figure 5-21)
appears in the sequence of AUX Pages. For complete
installation and configuration information refer to the
GDL 49 installation manual, Garmin P/N 190-00231-00.

Figure 5-21. Data Link Page

500 SERIES INSTALLATION MANUAL Page 5-15
P/N 190-00181-02 Rev G