26) PRINTHEAD STATE TABLE
Printhead state table select a fluid system state for the printer. Use the
cursor to select one of the following options, then press
selection:
C = Circulate
Defines the states used to bring up the printhead for diagnostic
operation.
N = Normal
Defines the states used to bring the printhead up or down during
normal operation.
P = Purge
Defines the states used during a fluid system purge.
Transitions between states take varying amounts of time.
Note: This parameter can only be changed while the printer is in the Down
State.
Remote Control Panel Procedures
↵
to confirm the
Operator's Guide
Keypad
37