2) SUBSTRATE LENGTH
Substrate Length enters a value for the length of the print area. If 0 (zero)
is selected, the print area length is determined by the cue sensor input.
The range for this parameter varies depending on the printer resolution as
follows:
•
120 dpi resolution = 0.0 to 136.0 inches (0.0 to 345.44 cm).
•
240 dpi resolution = 0.0 to 68.0 inches (0.0 to 172.72 cm).
•
480 dpi resolution = 0.0 to 34.0 inches (0.0 to 86.36 cm).
Use the arrow keys to position the cursor, then use the numeral keys to
enter a value and press
Note: This parameter cannot be changed while the printer is in the Ready State.
Remote Control Panel Procedures
↵
to confirm the entry.
Keypad
Operator's Guide
9