Remote Control Panel Procedures
Keypad
24
DP5000 Series Remote Control Panel
17) PRINTHEAD PHASE
Use the arrow keys to position the cursor, then press
selection.
Enter the value for the printhead charging phase, which appears on the
printhead label. This value is factory-set for the 5240 and 5122 printheads
(but not the 5120 printhead). Phase can be adjusted if problems with print
quality arise. The range is 1 to 55 counts. Check print quality after
adjusting this value. (See the DP5000 Series Operator's Guide for details
on verifying print quality.)
Note: This parameter cannot be changed while the printer is in the Ready State.
↵
to confirm the