Din Front Mount Installation - Boss Audio Systems 750DI User Manual

Installation
DIN front mount installation
Before you begin installing your new
!lO~
receiver, please become familiar
....,
......
with all the information contained in
this manual.
For details about installing the head
unit, read the instructions below and
refer to the diagrams for further
clarification.
~-
dashboard attachment
surface
/
5x 15mm
support screw
r
support screw
~
Insert and tighten the "headless"
support screw into the back of the
head unit as shown (Figure 1).
Insert the mounting case for the head
unit into the dashboard. Inspect the
dashboard material to determine its
approximate thickness. Select the
appropriate support tabs and bend
them outward to secure the bracket
in place (Figure 1).
Bend the support strap provided to
conform to the mounting case and
the dashboard surface to which you
plan to secure the support strap
(Figure 2). Slide one of the utility holes
on the support strap onto the support
screw and fasten it with the spring
washer and nut provided.
Using the 5 x 15mm screw and the
plain washer, secure the backstrap to
the dashboard surface as shown in
the diagram. Tighten, secure, and
check the overall mounting to be sure
it is safe and will not release in an
emergency stop or other sudden
movement of the vehicle.
5mmnut -
~
Figure 1 Bending the support 1abs
Before final installation of the unit,
temporarily connect the wiring and
make sure that the unit and system
work properly.
Avoid installing the unit in a location
which is subject to high temperatures,
direct sunlight, hot air from such
sources as heaters or exhaust lines,
or where it will be subject to contact
with dust, dirt, moisture or excessive
vibration.
head unit
Install the unit so that it does not get
in the driver's way and cannot injure a
passenger if there is a sudden stop.
Use only the installation parts and
hardware provided with the unit to
ensure proper installation. Using other
parts can cause malfunction and
possible damage to your receiver.
Consult with your nearest dealer if an
installation requires the drilling of holes
or other modifications to the vehicle.
~~,.
mou-,cue
-'l . . . .
support screw
Figure 2. Forming the support bracket
75001 User's Manual -
page
2